Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Fred_evans on January 17, 2015, 11:17:33 AM
-
" no spindle feedback seen in G95 units/rev mode "
Hello Chaps
what is the cure for the above error message??
Is there a published list of error codes that I can access ?
regards
fred
-
Do you have an index pulse from the spindle to Mach?
If not then that is why you get that message as it is looking for it and not seeing it so does not know if the rpm is as commanded.
Hood
-
thanks hood- i will check