Hello Guest it is October 11, 2024, 11:08:18 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Is it possible to reverse X & Y  (Read 2277 times)

0 Members and 1 Guest are viewing this topic.

Offline RoyT

*
  • 14 14
Is it possible to reverse X & Y
« on: October 10, 2014, 02:25:39 PM »
Hi

I have just replaced my controller and now my cnc seems to have reversed X & Y

is there a way in Mach3 to reverse them back again ?

I just ran a job and its Mirrored it ?  I assume that's another part of the same problem ?

Thanks

Roy
Logged

Offline ger21

*
  • *
  • 6,295 6,295
    • The CNC Woodworker
Re: Is it possible to reverse X & Y
« Reply #1 on: October 10, 2014, 05:11:59 PM »
Config > Homing/Limts > Reverse.
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Pages: 1   Go Up
« previous next »