Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: RoyT on October 10, 2014, 02:25:39 PM

Title: Is it possible to reverse X & Y
Post by: RoyT on October 10, 2014, 02:25:39 PM
Hi

I have just replaced my controller and now my cnc seems to have reversed X & Y

is there a way in Mach3 to reverse them back again ?

I just ran a job and its Mirrored it ?  I assume that's another part of the same problem ?

Thanks

Roy
Title: Re: Is it possible to reverse X & Y
Post by: ger21 on October 10, 2014, 05:11:59 PM
Config > Homing/Limts > Reverse.