Hello Guest it is April 16, 2024, 01:52:37 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Microkinetics MN400 Plugin anyone?  (Read 5317 times)

0 Members and 1 Guest are viewing this topic.

Offline Contract_Pilot

*
  • 24 24
    • View Profile
    • My Personal Blog
Microkinetics MN400 Plugin anyone?
« on: October 08, 2014, 02:40:02 PM »
Looking for a mach3 plugin for a Microkinetics MN400 controller? Anyone?
Logged

Offline Contract_Pilot

*
  • 24 24
    • View Profile
    • My Personal Blog
Re: Microkinetics MN400 Plugin anyone?
« Reply #1 on: October 10, 2014, 03:01:29 AM »
The Chips this controller is Using..

Pic18f4555
Xlinx XC95108
Analog Devices ADSP-2181
Logged

Offline THEARTISANHTX

*
  • 1 1
    • View Profile
Re: Microkinetics MN400 Plugin anyone?
« Reply #2 on: December 23, 2018, 02:48:22 AM »
Best advice is replace the breakout board, recently had an issue and ended up replacing it with the sainsmart 4axis breakout board.
Logged

Offline Contract_Pilot

*
  • 24 24
    • View Profile
    • My Personal Blog
Re: Microkinetics MN400 Plugin anyone?
« Reply #3 on: December 23, 2018, 04:06:57 AM »
Been a few years!! Check this out http://www.stevenrhine.com/?p=2432 on PathPilot (Linux CNC)
Logged
Pages: 1   Go Up
« previous next »