Microkinetics MN400 Plugin anyone?

Pages: 1 Go Down

0 Members and 1 Guest are viewing this topic.

« on: October 08, 2014, 02:40:02 PM »

Looking for a mach3 plugin for a Microkinetics MN400 controller? Anyone?

Logged

« Reply #1 on: October 10, 2014, 03:01:29 AM »

The Chips this controller is Using..

Pic18f4555
Xlinx XC95108
Analog Devices ADSP-2181

Logged

« Reply #2 on: December 23, 2018, 02:48:22 AM »

Best advice is replace the breakout board, recently had an issue and ended up replacing it with the sainsmart 4axis breakout board.

Logged

« Reply #3 on: December 23, 2018, 04:06:57 AM »

Been a few years!! Check this out http://www.stevenrhine.com/?p=2432 on PathPilot (Linux CNC)

Logged

Pages: 1 Go Up