Machsupport Forum
Mach Discussion => Mach SDK plugin questions and answers. => Topic started by: Contract_Pilot on October 08, 2014, 02:40:02 PM
-
Looking for a mach3 plugin for a Microkinetics MN400 controller? Anyone?
-
The Chips this controller is Using..
Pic18f4555
Xlinx XC95108
Analog Devices ADSP-2181
-
Best advice is replace the breakout board, recently had an issue and ended up replacing it with the sainsmart 4axis breakout board.
-
Been a few years!! Check this out http://www.stevenrhine.com/?p=2432 on PathPilot (Linux CNC)