Hello Guest it is June 20, 2019, 07:50:08 AM

Author Topic: Fusion 360 and Mach 3 post error  (Read 2394 times)

0 Members and 1 Guest are viewing this topic.

Fusion 360 and Mach 3 post error
« on: August 01, 2014, 11:41:01 PM »
Hi
I just generated my first code in Fusion 360. When I attempt to run the code I get this
error : Current point same as end point of arcLine 21. I was changing setting in the general
config section. I changed the Distance Mode and IJ mode hoping that a change would help
my error. Now I have no idea what those setting should be.
Need some help this is a bit over my head.

Offline Tweakie.CNC

*
  • *
  •  7,816 7,816
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Fusion 360 and Mach 3 post error
« Reply #1 on: August 02, 2014, 03:14:52 AM »
Hi Golash,

Normally, Distance Mode would be set to Absolute and IJ Mode set to Incremental.
Did changing the IJ Mode to Absolute solve the problem with running your code ??

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.