Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: golash on August 01, 2014, 11:41:01 PM
-
Hi
I just generated my first code in Fusion 360. When I attempt to run the code I get this
error : Current point same as end point of arcLine 21. I was changing setting in the general
config section. I changed the Distance Mode and IJ mode hoping that a change would help
my error. Now I have no idea what those setting should be.
Need some help this is a bit over my head.
-
Hi Golash,
Normally, Distance Mode would be set to Absolute and IJ Mode set to Incremental.
Did changing the IJ Mode to Absolute solve the problem with running your code ??
Tweakie.