So has anyone tried it yet ?

Is the jogging working OK ?

How about homing ?

Greg

Well 83 views and not one response in two and a half weeks 

This whole ncPod forum seems to have fallen off the shelf.

Don't know what happened to Kookaburra.  He hinted at some health issues.  Wish him well if that is so.

The OEMtech site has not sparked to life.

Perhaps there is discussion going on somewhere else but I don't know where.

This product seemed to me to have real potential. 

I would have expected those involved with it would be shouting from the rooftops.

Just seems to be dead.    I must admit to being a bit mystified.

Greg

I catch the information that may be a problem.
However, I cannot clarify this.
I think that I want the problem to improve by his hand.

I have a list of bugs but I was not going to post them at this time... we have been working and I have done about 6 hours of testing on it.
At this point I would say .. needs a bit more work but it is getting there!

.

I would have expected those involved with it would be shouting from the rooftops.

Brian I know that you and Art have been writing a plugin for it (in between all the other tasks  )

My comment was more to do with the people whose product this is.

We don't seem to have heard boo from them.

Greg

I know it is odd, but as long as they keep up with the bug fixes I am VERY happy

Hello everyone
I just plug my ncPOD for the first time about one hour ago.
At this moment I bough the mach3 last week but it is only today that I found some time to try it.
I did try the input pin and I have seen that they are not in the right order on the ncpod status, but at least they work.
Now because I am new with Mach3, I do not understand how to send some step out.
I did not connect on my CNC yet, but I have my scope on it right now.
Can anyone help me to use that new board so I can possibly connect it on my CNC
Thank's
Francoib

"2,019" new versions were found.
I was going to introduce it, but it was not accepted.
By a version of a board, will not you work?

"2,020" new versions were found.
Did somebody try to test it?
Did it work?

It is working... there are a few little roblems that we are working on at this time...

1.) If you have softlimits on and an axis reversed it will swap the jog keys (I know where the problem is and should be fixed today)

2.) Home pull off move is not using the right acceleration

Other then that it seems to be working well
Thanks
Brian