Hello Guest it is April 24, 2024, 03:09:04 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Port 1  (Read 2297 times)

0 Members and 1 Guest are viewing this topic.

Offline Robertwf

*
  • 6 6
    • View Profile
Port 1
« on: May 24, 2014, 06:49:06 PM »
 :-[
Hi all, I am running into a small problem.  I cant use the normal Port 1 for Mach 3 because it is used up by the mother board.  So I need some guidance as to what course of action I should take
Logged

Offline ger21

*
  • *
  • 6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: Port 1
« Reply #1 on: May 24, 2014, 08:40:31 PM »
Mach3's Port1 is not the same as LPT1. Just enter the address of the port you want to use for Port 1 in Mach3.

Port 1 in Mach3 can be any parallel port.
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline Robertwf

*
  • 6 6
    • View Profile
Re: Port 1
« Reply #2 on: May 25, 2014, 05:33:32 PM »
GER 21,
Thanks for that tidbit of useful information.  I will use it today
Logged
Pages: 1   Go Up
« previous next »