Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Robertwf on May 24, 2014, 06:49:06 PM
-
:-[
Hi all, I am running into a small problem. I cant use the normal Port 1 for Mach 3 because it is used up by the mother board. So I need some guidance as to what course of action I should take
-
Mach3's Port1 is not the same as LPT1. Just enter the address of the port you want to use for Port 1 in Mach3.
Port 1 in Mach3 can be any parallel port.
-
GER 21,
Thanks for that tidbit of useful information. I will use it today