You check the CAD/CAM layout 100 times, you check the engraved part, you screw it up – stand back to admire and bang the mistake is obvious. 

Tweakie.

Have to assume you sawed through it? Cause I have no idea what it says.
Nice clean graphics work your providing.

Thanks Craig.  

(Perhaps I should have taken the full picture - it's the annotation for my 'Weather Stone' and the black line is the string suspending the actual stone).

Tweakie.


addendum:  It gets worse - only since looking at it again here, I have noticed there is more than one mistake 

The suspense was killing me. I almost bit first ... THANKS Craig 

It does look very nice Tweakie, was looking for a typo but am not familiar with that particular lingo. All looks spelt rite to me.

Thanks,
Russ
 

Slightly out of plumb ? ? or, is there a breeze ?
Russ

I make no excuses fellas - it was a holiday weekend, with friends around, and we all had a modicum of beers before we set about this project.

Yes Russ, out of plumb as well 

Tweakie.

Tweakie,
I'm pretty sure I see the mistake(s), and the beers are certainly an acceptable excuse, but then I'll not be the one to spoil your party.   
All the Best,
John Champlain

What beems to be the soblem Tweakie?

Brett

So you plumbed it holding a long neck bottle?
hell... close enough then.

Looks like the order might be unconventional ... or mismatched. ? ?

That little bit of pure English looks out of place as well. ? ?

Other than that, it looks gurty pood.

Russ