Thanks Zasto, I have read the manual, watched the videos, and yet I have difficulty understanding how the whole process works. I have referenced all the axis as per instructions but it still won't cut in the right direction e.g I will jog it to where I want it to cut, zero the axis, instead of going in the x+ and y+ direction to cut it will actually move to the x- and y- an then start to cut. It is not the lack of reading the manual, but probably lack of understanding how it works.
Nick
You messed something with settings.
Here are settings for a router that I'm using.
Machine is homing to the lower/left, jogs in the right directions, executes G Code in right directions.
As you will notice, I'm using same switch for Home/-- limit and Soft Limits.
Thanks for the pics Zasto, I have some of the settings different, but after changing them to look very similar to yours, it worked, I still not sure if I understand the X++ and Y++ etc, what they actually do if the whole lot of them were enabled like mine were, I could not find it in the manual, where it says you either enable one or the other or both, e.g Y++, X++, Y-, and X-, I may have overlooked it or didn't understand the explanation, OR maybe ALZHEIMERS is starting to kick in!!
Cheers
Nick