Hello all,
I have a Dell Inspiron 8100 notebook (1Ghz) running Mach3 Ver 2.0.054. Using my original XML file that I backed up from a previous version, my router runs fine, however, if I open 'Config Motor Tuning' and then close it again, the router no longer runs - jogging does move the motors but at such a fine amount it is hard to detect movement although the DRO's appear to be changing correctly. Reloading the original backup XML file fixes the problem until I open motor tuning again. The only entries that look different in the config settings are the Step Pulse and Direction Pulse - if I set these to 3 close the 'Config Motor Tuning' and then open it again these have change to 2? Close and open the motor tuning again and they have reduced to 1 and again and they become 0. I doubt that this alone is stopping the router from running but I am puzzled why something changes by just opening the config motor tuning and closing it again.
Any help would be greatly appreciated.
Alan