Last night I started cutting a job, homed the machine, set my WC 0,0 then I cut the first MOP, no problems at all, after that was finished and the machine was back at WC 0,0 I wrote down the machine coords for X and Y assuming that would stay the same, this morning I homed the machine the same way and moved to the machine coords that I saved last night thinking it would put me back to my WC 0,0 however this was visibly not even close to where my WC 0,0 was last night, it was off by almost 1 inch in X and Y.
I have no idea why this would be different, does this have something to do with loosing steps, maybe during the first MOP I did last night on the piece ?
Any help would be appreciated, so I don't screw up like this again
Thanks,
John