Hello folks, I'm in the process of finishing my EMCO lathe rebuild and have loaded a fresh copy of Machturn... .066 version...onto the computer.
I've kind of run into a small annoyance inputting data in ports and pins. For example, I want to set output 5 to port 1 and pin 8, when I click on the pin or port box, the output 5 box changes to an enable box, instead of staying at output 5.
I then have to close out the ports and pins..reopen it and try again. After a couple attempts, I will finally get it. I've had the same issue helping a friend setup his lathe. One other thing, It appears that at times I have to close Mach and reopen it to save the data inputted.
Has anyone experienced these hiccups
? Am I doing something wrong?
thanks