Also many of the Gcodes will change.. We can add script calls to shift the machine into Mill mode for you out there with milling on a lathe

This may not be used by many right now but I think it will be soon. 

Brett

Yes this is in Mill and in turn.. So you will have CSS and Feed per rev in turn and mill and we don't care where you get the RPM from as long as we can get it This was all scripted in for the demo that I did.

Also many of the Gcodes will change

Brian,
So what will be the basis of the new Gcodes.......ie: Smid?
If not what?

And while we are it, at a high level of thought, do you have any strong thoughts  on what the lathe screen should look like?

BTW,answers to the above will save ya "5 minutes"  
Rich

We are going to make it like Fanuc for lathe and mill so it should be like Smid

Brian,
Thanks for the info and I'll need to review the differences in the dialects of code.
RICH