Hello Guest it is April 20, 2019, 10:52:23 PM

Author Topic: GREMLINS in the works  (Read 1669 times)

0 Members and 1 Guest are viewing this topic.

GREMLINS in the works
« on: August 11, 2013, 07:03:21 AM »
Hi there, after solving the PC problem by buying another PC, I have found some "gremlins in the works", I keep getting a re-set signal when running Mach3, error report shows "driver watch dog triggered" or "limit switch triggered" I can understand it if the cnc machine was even turned on but it is not even connected!!!! any one out there with any thoughts or ideas I would greatly appreciate hearing from you.

Regards
Nick   ??? >:D >:D

Offline ger21

*
  • *
  •  6,204 6,204
    • View Profile
    • The CNC Woodworker
Re: GREMLINS in the works
« Reply #1 on: August 11, 2013, 07:32:01 AM »
Disable watchdogs in General Config and see if you still get errors.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Re: GREMLINS in the works
« Reply #2 on: August 13, 2013, 07:13:07 AM »
 Thanks for the info ger21, it seems to have worked. ;D