Hello,
We are trying to setup a Kitamura T-12, that has already been setup using a Galil DMC-1840 pci card and a Contec 16 I/O card. It has the original DC motors and includes the automatic tool changer. The machine was fully functional with the current setup, but was decommissioned. We have since purchased the machine, and are attempting to get it running. Apparently the machine was removed in a running condition, so should be fairly simple to get going again? Everything is still there except the computer, however we have the original cards from it.
We are using a fresh computer to run the machine, running windows XP. We have successfully installed the PCI drivers, DMC Smart term and Mach 3 Trial to get us going.
All of the software recognises the controller fine. We have installed the Contec drivers, but not the Contec Mach plugin?
We have powered the machine up, and we are unsure where to go to from here, as far as moving axis or downloading the data that was burnt to the pci card when it was last running.
Any help would be greatly appreciated.