Hood,
The C25 break out board doesn't have an enable terminal.
stepper drives enable inputs? Where is that at?
A while back, I touched on this subject with Arturo, and these are his replies:
Mike,
Please note that the original wiring diagram for your machine showed e-stop as removing power to the entire system. We did not change that, as that is how the original equipment manufacturer designed it, and I do not like changing this without been familiar with the machine.
In this case, I would suggest that you connect the enable in series with the existing e-stop button.
Please verify that power consumption of the system does not exceed the ratings of the relay.
Arturo Duncan
Hood, here I was referring to the wiring instruction for the C22 pendant interface board. And here is Arturo's reply:
Mike,
This wiring diagram does not apply to the C25 as the C25 does not have an external enable terminal.
Arturo Duncan