Ok so my HNC leaks air badly. I use a brain to open the air when ever the machine is running or spindle is on.
Also if I open/close collet do tool change or cutoff or jog. it uses the 'is running' as a trigger.
what i would like is for the air to stay on during and for 10-30 sec after any of these operations.
if you have any ideas please share them.
Thanks Drew

Hi Drew,

attached a brain.

Output3 = Spindle
Output4 = Coolant
Output1 = air

hope that helps

Alex

ok i have been working on new brain
but cant seem to figure out to select several inputs for an And or OR lobe
I know i have done this before
can someone point the way
Thx Drew

I watched the video again
add no-op before lobe

Hi Drew,
please post which outputs do you want to turn the air on, and which output is the air.


Alex