Machsupport Forum
Mach Discussion => Brains Development => Topic started by: drew on March 14, 2013, 05:47:08 PM
-
Ok so my HNC leaks air badly. I use a brain to open the air when ever the machine is running or spindle is on.
Also if I open/close collet do tool change or cutoff or jog. it uses the 'is running' as a trigger.
what i would like is for the air to stay on during and for 10-30 sec after any of these operations.
if you have any ideas please share them.
Thanks Drew
-
Hi Drew,
attached a brain.
Output3 = Spindle
Output4 = Coolant
Output1 = air
hope that helps
Alex
-
ok i have been working on new brain
but cant seem to figure out to select several inputs for an And or OR lobe
I know i have done this before
can someone point the way
Thx Drew
-
I watched the video again
add no-op before lobe
-
Hi Drew,
please post which outputs do you want to turn the air on, and which output is the air.
Alex