I got the new computer built, loaded the latest Mach3, put in my saved XML, created the proper Icon, loaded in my plugins for pokeys and machmotion. I basically tried to put everything back like it was in the old computer.
When I run the drivers test I get "Pulsing too fast". Kernel speed is 25k.
The computer was built to be dedicated to the mill. I have not actually hooked the computer to my machine yet.
Intel i3 3225
Gigabyte GA-B75M-D3H MATX Motherboard
Sandisk Extreme 120 Gig SSD drive
Kingston HyperX Red 4GB DDR3-1600 (PC3-12800) CL 9 Memory Module
LG 24x Super Multi Internal SATA DVDRW DL Drive
Parallel port PCI card (has one port on board and one that ribbon cables off) - The same card from old computer
PCI wireless network card - The same card from old computer
Windows 7 32-Bit
I did try turning off all services and startups in the msconfig, then rebooted, and that did not change anything.
I am looking for ideas to try next. Sometimes during the test it will say system stable for a bit, then go back to pulsing too fast.