Hi!

Is it possible to use MODBUS TCP in Mach3 r2.48?

I tried to send some data to slave device in current version of Mach3 (R3.043) successfully.
But when I tried to use same configuration in r2.48 there was no data on slave device. Mach3 send only zeroes continuously. But in same time MODBUS TCP testing was OK.
I think that problem is connected with differences in BRAIN programs. In r3.043 I could select number of cfg to use, but in r2.48 I can only select the MODBUS address.

My clients use r2.48 and they don't want to upgrade to new version.

Best regards,
Alexey Kozletsov