Steve & Kenny, (and Darak),
Kenny I put the galil.dll you sent me into mach3 plugins, Darak I downloaded and installed Smart term 7.
We are a little closer, but still no cigar..... I can now see the Galil plug in as an option in my plugin config, BUT!!! As soon as I enable it
it CRASHES Mach instantly!!!! I get the choice to debug, or retry, or close, but no matter what choice, it dies.... I tried it several times...
Some possible issues from my end that may be causing the crash are:
1). I dont actually have a Galil Card hooked to the Laptop since I am just trying to get the plugin to run.
2). Unfortunatly, I have a new laptop, since while in TX last week, my laptop dropped and died.... I had to goto
best buy and get another one to complete my job there. My ONLY choice was a Vista 64 powered Laptop there was not
any 32's and definatly no XP.........
Since I was running Vista 32 on the old laptop, I got Mach3 working and VS2003 working again on it, pain in the ass work around
but do-able.
If I have to have a Galil Card attached, then just let me know and I will shut up, for now until I get one. BUT, I am stuck with the new Laptop
I did find out that if I HAVE to, I can "Down Grade" to Vista 32, since the laptop I bought has drivers avail for both 32 and 64 systems.
Let me know,
scott