Hi Guys,
I have an old Galil DMC-1750 card that I am trying to install but I am having problems.
I made the mistake of putting the card in before the software.
Here is where I am at the moment.
Fresh install of win2k including drive format.
go to add hardware and configure for the card.
Install galil smart term.
Power down and install card.
Reboot and the card looks good in device manager.
Open Smart term and it has a communications timeout error.
Open the Galil registry thingy and the card is there with the proper settings.
I have IRQ5 selected by jumper and no conflicts.
No address jumpers which is 1020 or 03fc. No conflicts there either.
I have dma1 selcted and I have tried dma0 also.
Any Ideas?
If the card is no good then that is fine but I would hate to toss it if it is just a configuration error.
Mike