Hello Guest it is April 18, 2024, 04:02:20 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Can't map inputs to Mach with 56E  (Read 2724 times)

0 Members and 1 Guest are viewing this topic.

Offline mechaniac

*
  • 13 13
    • View Profile
Can't map inputs to Mach with 56E
« on: May 10, 2012, 05:48:55 AM »
Hi,
I have a problem  matching inputs to mach. With the new Plugin (201204v2) i can configure the device properly, the settings are correct shown in the configuration tool also, but i have no response from Mach (Version 42.036). Have i forgot something to configure? Unfortunately i haven't found any documentation about this plugin. Firmware is 3.0.29. Serial: 20936. I have attached a screenshot. Can anybody help me?

Thanks,
Helmut
Logged
In theory, there is no difference between theory and practice. In practice there is.

Offline NeoTO

*
  • 504 504
    • View Profile
    • PoLabs
Re: Can't map inputs to Mach with 56E
« Reply #1 on: May 10, 2012, 05:45:52 PM »
You should use button 1900 to toggle Jog On LED. This one is 'read-only' - can only be mapped to an output.
Logged
www.poscope.com home of PoKeys USB HID, IO, USB, Ethernet controler and PoScope USB PC oscilloscope

Offline mechaniac

*
  • 13 13
    • View Profile
Re: Can't map inputs to Mach with 56E
« Reply #2 on: May 11, 2012, 03:53:50 AM »
Hi,
Thank you very much, now it works perfect! Sorry for the stupid question, but yesterday i was a little bit confused  ;)

Thanks again,
Helmut
Logged
In theory, there is no difference between theory and practice. In practice there is.
Pages: 1   Go Up
« previous next »