Machsupport Forum
Third party software and hardware support forums. => PoKeys => Topic started by: mechaniac on May 10, 2012, 05:48:55 AM
-
Hi,
I have a problem matching inputs to mach. With the new Plugin (201204v2) i can configure the device properly, the settings are correct shown in the configuration tool also, but i have no response from Mach (Version 42.036). Have i forgot something to configure? Unfortunately i haven't found any documentation about this plugin. Firmware is 3.0.29. Serial: 20936. I have attached a screenshot. Can anybody help me?
Thanks,
Helmut
-
You should use button 1900 to toggle Jog On LED. This one is 'read-only' - can only be mapped to an output.
-
Hi,
Thank you very much, now it works perfect! Sorry for the stupid question, but yesterday i was a little bit confused ;)
Thanks again,
Helmut