Hello Guest it is December 11, 2019, 11:19:29 PM

Author Topic: configuration is out by 180 degrees for some reason?  (Read 1483 times)

0 Members and 1 Guest are viewing this topic.

configuration is out by 180 degrees for some reason?
« on: April 13, 2012, 11:50:30 PM »
I have just finished assembling a new controller for a Routermaster 52. It all seems to work fine, but I need to rotate my image by 180 degrees. I am assuming this is possible.

When I load Gcode it displays correctly in the toolpath window. When I run it, it cuts out by 180 degrees. I suppose the simple solution would be to turn my maching around, but thats not really a solution.

Any ideas?

(please have a look at the attached images)

Thank you

Offline Hood

*
  •  25,856 25,856
  • Carnoustie, Scotland
    • View Profile
Re: configuration is out by 180 degrees for some reason?
« Reply #1 on: April 14, 2012, 06:19:03 AM »
You seem to have the axis backwards, change the Dir active low settings for your axis in Motor tuning and see if that helps you.
Hood
Re: configuration is out by 180 degrees for some reason?
« Reply #2 on: April 14, 2012, 01:38:29 PM »
I did what you suggested... and it WORKED PERFECT !

Thank you so much for the suggestion!