Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: getrolfed on April 13, 2012, 11:50:30 PM

Title: configuration is out by 180 degrees for some reason?
Post by: getrolfed on April 13, 2012, 11:50:30 PM

I have just finished assembling a new controller for a Routermaster 52. It all seems to work fine, but I need to rotate my image by 180 degrees. I am assuming this is possible.

When I load Gcode it displays correctly in the toolpath window. When I run it, it cuts out by 180 degrees. I suppose the simple solution would be to turn my maching around, but thats not really a solution.

Any ideas?

(please have a look at the attached images)

Thank you

Title: Re: configuration is out by 180 degrees for some reason?
Post by: Hood on April 14, 2012, 06:19:03 AM

You seem to have the axis backwards, change the Dir active low settings for your axis in Motor tuning and see if that helps you.
Hood

Title: Re: configuration is out by 180 degrees for some reason?
Post by: getrolfed on April 14, 2012, 01:38:29 PM

I did what you suggested... and it WORKED PERFECT !

Thank you so much for the suggestion!