I have just finished assembling a new controller for a Routermaster 52. It all seems to work fine, but I need to rotate my image by 180 degrees. I am assuming this is possible.

When I load Gcode it displays correctly in the toolpath window. When I run it, it cuts out by 180 degrees. I suppose the simple solution would be to turn my maching around, but thats not really a solution.

Any ideas?

(please have a look at the attached images)

Thank you

You seem to have the axis backwards, change the Dir active low settings for your axis in Motor tuning and see if that helps you.
Hood

I did what you suggested... and it WORKED PERFECT !

Thank you so much for the suggestion!