Tried some screwcutting this morning with no luck.
On the auto screen, s true, builds up revs and then drops to zero and yellow bar lights up. X axis goes in but z does not traverse.
In the diagnostics screen output 2 briefly flashes then output one lights up permanently at the beginning of screwcutting.
I have still not got my head round ports,pin,etc.
Is port the main input plug into BOB? As in my set up I am using both parallel and series as main input plugs.
Then I presume the pin is the actual connection within the plug to what??? in the BOB thats where I loose track of setting up the other parameters!!!
I have tried following through the Mach 3 PDF,s but they seem to be for the earlier version of mach. I am on version .62
Any help would be appreciated.
Graham