Hello Guest it is April 16, 2024, 07:04:30 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Question regarding mach3 function  (Read 2006 times)

0 Members and 1 Guest are viewing this topic.

Offline Saumur

*
  • 79 79
    • View Profile
Question regarding mach3 function
« on: September 02, 2011, 11:15:24 AM »
Hi guys,

I was wondering if in one of the latest version of Mach3 lathe, or using a created program, is there a function that stops the machine with an error IN CASE the drives are not giving the correct pulses to the computer.

Thanks
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Question regarding mach3 function
« Reply #1 on: September 02, 2011, 11:43:38 AM »
Drives take the pulses not give.
However if your drives support fault output signals then you can put them in to Mach to halt all motion if one axis faults.
Hood
Logged
Pages: 1   Go Up
« previous next »