Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Saumur on September 02, 2011, 11:15:24 AM

Title: Question regarding mach3 function
Post by: Saumur on September 02, 2011, 11:15:24 AM

Hi guys,

I was wondering if in one of the latest version of Mach3 lathe, or using a created program, is there a function that stops the machine with an error IN CASE the drives are not giving the correct pulses to the computer.

Thanks

Title: Re: Question regarding mach3 function
Post by: Hood on September 02, 2011, 11:43:38 AM

Drives take the pulses not give.
However if your drives support fault output signals then you can put them in to Mach to halt all motion if one axis faults.
Hood