Hello Guest it is August 11, 2020, 06:42:26 AM

Author Topic: Question regarding mach3 function  (Read 1480 times)

0 Members and 1 Guest are viewing this topic.

Question regarding mach3 function
« on: September 02, 2011, 11:15:24 AM »
Hi guys,

I was wondering if in one of the latest version of Mach3 lathe, or using a created program, is there a function that stops the machine with an error IN CASE the drives are not giving the correct pulses to the computer.


Offline Hood

  •  25,846 25,846
  • Carnoustie, Scotland
    • View Profile
Re: Question regarding mach3 function
« Reply #1 on: September 02, 2011, 11:43:38 AM »
Drives take the pulses not give.
However if your drives support fault output signals then you can put them in to Mach to halt all motion if one axis faults.