Thanks Tweakie and BR549,
basic question here. I have a screenshot of my Mach inputs config, but I don't know how to insert it into this post.
Can't find any real instructions to upload images. Does the image have to be on a website? When I select insert image I get a piece of code that will only take a url.
I am running Windows7 32bit, version 6.1.7601
PCI ECP parallel port (LPT1) address E800-E807 (the machine works in Mill profile)
In Mach Mill-P profile the Config/ports and pins/input signals shows my Estop is enabled (checked green) on port 1 pin 16, came this way from the mfr. I do not know why this is different from Tweakie's post, the estop works, at least in Mill profile. Since I haven't been able to get the probe to move, I don't know if this is different in Mill-P profile.
In Mach Config/ports and pins/input signals my Probe is enabled on port 1 pin 10
No other inputs are enabled.
I hope I have answered all the questions.
I believe that most of my confusion is related to the disconnect between where the wires are on the Gecko and which parallel pin is assigned in Mach.
As soon as I can figure out how to post an image I will take snapshots and post them.......
thanks,
Vicrider