I put comments in the gcode file for tooling. Giving back to those I have learned from.
This was cut in MDF so I could test my entire gcode file. I haven't figured out offsets yet so I use G92 and G92.1 instead. Either way it works.
These are the comments I put in the gcode file:
(Deer drink coasters)
(chucks v-carve pro deer, Artsoft.com)
(Material 10"x10"x.5000)
(1st tool 60* vbit)
(2nd tool 1/4" end mill)
(Zero at lower left corner of material)
(move to X2.25, Y2.25 and rezero)
(Z0=top of material)
10x10 isn't necessary as you can tell by the pictures. 9.5x9.5 will suffice.
If anyone wants to help me figure out offsets, I'm all ears.