Author Topic: Chucks Deer V carve engraving  (Read 49275 times)

0 Members and 1 Guest are viewing this topic.

Offline dirk blanston

  • Holding
  • Posts: 2
    • View Profile
Re: Chucks Deer V carve engraving
« Reply #30 on: June 02, 2016, 08:09:30 PM »
Hi all.  First time poster and new to CNC.  I have been looking for a 3d rope file.  Found and downloaded      rope border rectangle.dxf    .  I cant open it in inkscape.   How do i use the file and eventually get it to gcode?  thanks

Offline dirk blanston

  • Holding
  • Posts: 2
    • View Profile
Re: Chucks Deer V carve engraving
« Reply #31 on: June 02, 2016, 08:16:01 PM »
forgot to give my specs.  xcarve using easle.  I can use inkscape to convert dxf to svg and upload svg to easle for gcode conversion and sending to cnc.   xcarve is arduino based so no mach3.
dirk

Offline Tweakie.CNC

  • Global Moderator
  • *
  • Posts: 7,643
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Chucks Deer V carve engraving
« Reply #32 on: January 11, 2017, 06:59:39 AM »
For those who have yet to purchase the Mach3 license and are running in Demo Mode I have re-worked the Chucks Deer Gcode file to get it down to just below the 500 line limit. To avoid duplication the Gcode file is included in the .zip folder here; http://www.machsupport.com/forum/index.php/topic,18345.msg126486.html#msg126486

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.

Offline npalen

  • Active Member
  • Posts: 26
    • View Profile
Re: Chucks Deer V carve engraving
« Reply #33 on: November 20, 2017, 10:51:38 PM »
Ran across this by accident and tried it out.  Going to use it on my grandson's gun cabinet that he is building.

Offline tjstamp

  • Active Member
  • Posts: 73
    • View Profile
Re: Chucks Deer V carve engraving
« Reply #34 on: November 21, 2017, 06:44:26 AM »
I just used it on a sign I made for a friend.