Mach and LC are installed in my office Laptop where I learn both software and also in my shop where I do the cutting. In both computers I first load Mach and from Mack I load LC
In my office Laptop when I finish a project in LC and I say post gcode, I switch to Mach and the gcode is there and I can see my project on the display window. However in the shop computer when I say to LC post gcode I get the message “No Mach3 found running”. Then I have to go to file open on Mach, select the gcode and open it.
I have re installed Mach and LC in the shop computer but the results are the same
What am I doing wrong?