Hi Hood,
I was trying to put it to the left of the X & Z DRO's and zero buttons on the standard screen. Thie other screen I downloaded with the A DRO and zero button from the forum seems to be working well and it does have a diagnostic page.
The problem I have now is that when I move from tool 1 to tool 2, G00 A46 followed by G00 A-40 to return against the ratchet (DRO shows 40 degrees) Then Move to Tool 2 by G00 A91 it moves the tool 51 degrees which requires a larger negative move to return against the ratchet. I know I could just say G00 A85 to get to tool 2 bbut I think that is going to get messy.
Is there a way that I could set the A DRO to the proper value for the tool after the move in the macro? ie After the G00 A-40 set the A DRO to 45.
Regards
Art