Hello Guest it is April 16, 2024, 08:14:35 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Rapids  (Read 3759 times)

0 Members and 1 Guest are viewing this topic.

Offline Graham Waterworth

*
  • *
  • 2,671 2,671
  • Yorkshire Dales, England
    • View Profile
Rapids
« on: November 18, 2006, 07:50:05 AM »
Hi all

I have just got this boxford running on stepper motors, never used them before its always been servos.

my question is this :-

if I can jog at 750 units/min why wont it rapid at that under G00 command?, it stalls out

Graham.
Logged
Without engineers the world stops

Offline Brian Barker

*
  • *
  • 3,859 3,859
    • View Profile
Re: Rapids
« Reply #1 on: November 18, 2006, 08:17:50 AM »
What are your accel settings for each axis?
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Offline Graham Waterworth

*
  • *
  • 2,671 2,671
  • Yorkshire Dales, England
    • View Profile
Re: Rapids
« Reply #2 on: November 18, 2006, 09:30:49 AM »
Hi brian,

Setting so far

X 800 pulses/mm 1500 vel 150 acc
Y 800                 1200     150
Z 880                  1000     75

Jogging is fine, just cant get it to rapid without stalling, I have tried all sorts of combinations without any luck.

Graham.
Logged
Without engineers the world stops

Offline Graham Waterworth

*
  • *
  • 2,671 2,671
  • Yorkshire Dales, England
    • View Profile
Re: Rapids
« Reply #3 on: November 18, 2006, 11:11:05 AM »
Hi All,

I have got it sorted,  all is well on the movements, now onto the spindle.

Graham.
Logged
Without engineers the world stops
Pages: 1   Go Up
« previous next »