Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Graham Waterworth on November 18, 2006, 07:50:05 AM
-
Hi all
I have just got this boxford running on stepper motors, never used them before its always been servos.
my question is this :-
if I can jog at 750 units/min why wont it rapid at that under G00 command?, it stalls out
Graham.
-
What are your accel settings for each axis?
-
Hi brian,
Setting so far
X 800 pulses/mm 1500 vel 150 acc
Y 800 1200 150
Z 880 1000 75
Jogging is fine, just cant get it to rapid without stalling, I have tried all sorts of combinations without any luck.
Graham.
-
Hi All,
I have got it sorted, all is well on the movements, now onto the spindle.
Graham.