Hello Guest it is March 28, 2024, 11:22:22 AM

Author Topic: Multi-pull Galil controllers  (Read 2318 times)

0 Members and 1 Guest are viewing this topic.

Multi-pull Galil controllers
« on: December 13, 2010, 06:45:56 PM »
HI

Could I use a galil DMC-2040 and DMC-2020 together on Mach 3
Serial cable going from PC to the DMC-2040 and and then chaining onto the the DMC-2020

IF yes then do I do the same with the USB cable?

thanks
Musky

Offline smurph

*
  • *
  •  1,544 1,544
  • "That there... that's an RV."
    • View Profile
Re: Multi-pull Galil controllers
« Reply #1 on: December 14, 2010, 01:15:08 AM »
Using two Galil controllers to gain axes is not possible.  :(

Also, you will need to use USB for the connection instead of Serial.

Steve