Machsupport Forum
Third party software and hardware support forums. => Galil => Topic started by: Muskymistry on December 13, 2010, 06:45:56 PM
-
HI
Could I use a galil DMC-2040 and DMC-2020 together on Mach 3
Serial cable going from PC to the DMC-2040 and and then chaining onto the the DMC-2020
IF yes then do I do the same with the USB cable?
thanks
Musky
-
Using two Galil controllers to gain axes is not possible. :(
Also, you will need to use USB for the connection instead of Serial.
Steve