Hello Guest it is May 19, 2025, 08:17:56 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Denford Novamill conversion  (Read 6988 times)

0 Members and 1 Guest are viewing this topic.

Offline Mike Goode

*
  • 11 11
Denford Novamill conversion
« on: October 02, 2010, 04:44:19 AM »
Could anyone tell me how to convert and older MSDOS Novamill to Mach3 please. Am I right in thinking I will only need a breakout board and drive card for each stepper motor? If that is the case I think I would be able to handle the interconnections.
Logged

Offline Graham Waterworth

*
  • *
  • 2,782 2,782
  • Yorkshire Dales, England
Re: Denford Novamill conversion
« Reply #1 on: October 02, 2010, 05:53:38 AM »
I would look at the Denford forum, there are quite a few conversions on there and some are very well documented.

Graham
Logged
Without engineers the world stops
Pages: 1   Go Up
« previous next »