Machsupport Forum

G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: Mike Goode on October 02, 2010, 04:44:19 AM

Title: Denford Novamill conversion
Post by: Mike Goode on October 02, 2010, 04:44:19 AM
Could anyone tell me how to convert and older MSDOS Novamill to Mach3 please. Am I right in thinking I will only need a breakout board and drive card for each stepper motor? If that is the case I think I would be able to handle the interconnections.
Title: Re: Denford Novamill conversion
Post by: Graham Waterworth on October 02, 2010, 05:53:38 AM
I would look at the Denford forum, there are quite a few conversions on there and some are very well documented.

Graham