Hello Guest it is November 26, 2022, 11:25:26 AM

Author Topic: Denford Novamill conversion  (Read 2861 times)

0 Members and 1 Guest are viewing this topic.

Denford Novamill conversion
« on: October 02, 2010, 04:44:19 AM »
Could anyone tell me how to convert and older MSDOS Novamill to Mach3 please. Am I right in thinking I will only need a breakout board and drive card for each stepper motor? If that is the case I think I would be able to handle the interconnections.

Offline Graham Waterworth

*
  • *
  •  2,497 2,497
  • Yorkshire Dales, England
    • View Profile
Re: Denford Novamill conversion
« Reply #1 on: October 02, 2010, 05:53:38 AM »
I would look at the Denford forum, there are quite a few conversions on there and some are very well documented.

Graham
Without engineers the world stops