Hi All,
I added pushbuttons to my control panel for Jog Cont. and Jog Step. Now I would like to add leds so I know which is active. I wired an led with a 220 ohm resister from 5vdc source to BOB2  pin1. Then in Ports & Pins/Output/, I choose  Output2 and entered 2 for ports, and 1 for pins, and choose Active low. Wrote a brain with Jog Cont Led as input, to Pass Signal/No Operation to Output2. The brains switches on when I'm in JogCont, but the led always stays lit. What am I doing wrong?
Johnv

Can  you attach the Brain please.
Hood

Hood,
I spent the last 15 min trying to figure out how to attach a file. Would you tell me how this is done?
Johnv

Additional options button on the reply page.
Hood

Hood,
Thanks!
Johnv

It seems to be working fine here. See the screen capture I took and posted on youtube.
http://www.youtube.com/watch?v=hI0_c_fuS28
Do you see the same when you view the Brain and work via the flyout screen?
Hood

Hood,
Yes! I get the same action. I shut down the system for about 5 minutes and rebooted.... It works fine now!   I hate when I can't find the cause of these malfunctions! Thanks again Hood.
Johnv

Hopefully it will keep working from now on
Hood