Hello
Guest
it is
April 25, 2024, 02:28:12 AM
Guest
Login
Register
Menu
Home
Help
Search
Calendar
Members
Members
View the memberlist
Search For Members
Login
Register
YouTube
Machsupport Forum
/
Mach Discussion
/
General Mach Discussion
/
Auto Zero Touch pad and c10 (cnc4pc board)
« previous
next »
Print
Pages:
1
Go Down
Author
Topic: Auto Zero Touch pad and c10 (cnc4pc board) (Read 3243 times)
0 Members and 1 Guest are viewing this topic.
ardsranger
7
Auto Zero Touch pad and c10 (cnc4pc board)
«
on:
September 23, 2010, 12:18:19 PM »
I think i would like to build me a touch pad to use for Zeroing my Z axis.
I have a c10 board from cnc4pc. Which pin will i attach the leads to?
What is the command in Mach3 to have the mill come down and zero the Z?
Or do i move it down with MPG until it hits the pad?
Im just not sure of the process after i wire up the pad to use it.
Thanks for the help bob
Sorry the question is not worded better
Logged
Hood
25,835
Carnoustie, Scotland
Re: Auto Zero Touch pad and c10 (cnc4pc board)
«
Reply #1 on:
September 23, 2010, 03:07:44 PM »
You need to use a macro to do the tool setting, there are a few about and you should find them if you search for
auto tool zero
As for pin on the breakout, any spare input should be fine.
Hood
Logged
Kendall.Miller
19
Re: Auto Zero Touch pad and c10 (cnc4pc board)
«
Reply #2 on:
August 14, 2011, 01:19:11 PM »
Has anyone out there wired a touch pad into a Syil X4 control cabinet. I am not an electrician, and when I open the cabinet door, I am overwhelmed.
Logged
Kendall.Miller
19
Re: Auto Zero Touch pad and c10 (cnc4pc board)
«
Reply #3 on:
August 14, 2011, 01:22:17 PM »
And when I wired in my coolant pump, I found that the inside components were not laid out as the cabinet schematic, Syil China had to send me marked up pictures of where they moved things and which component was what...
Logged
Print
Pages:
1
Go Up
« previous
next »