Thanks Scott
for fixing my screw up
Used to hold an Allen Bradley SLC 503 PLC (Programmable Logic Controller)
with 4 thermocouple module and a 6 input/6 output Relay I/O module
Controls my Fireplace blower (when to come on and off based on temps in Plentem and the room)
Also Gives me the temps of four zones (Room, Basement, Outside, and the Plentem in the fireplace)
and controls one electrical outlet that I use to turn on and off a light I plug into it.
Programed it to come on in the early morning and again in the evening for a few hours.
Everything is programed and monitor from the Panelview 600 HMI (Human Machine Interface)
Even created some ladder logic to compute the day of the week. Fun little bit of programming!
Used Boiled Linseed Oil to finish the bamboo (called Plyboo) box, a very hard wood.
Added a little engraving.
Hidden cabinet door hinges at the bottom to get access to the PLC and wiring.
Beautiful wood to work with, finishes well on the face, sides and ends.
Project I been wanting to do for years.
Just got it hung up so have not finished installing the temp probes as of yet.